5/27/2023 0 Comments Ps1 controller pinoutThis wire is usually white in a standard USB cable. You cannot reprogram the microprocessor through this interface. It is used to change software parameters after the microprocessor has already been programmed. This connection is for the USB interface. You can use this ground for the USB interface, Throttle, etc. J5 PinĬAN BUS is not yet implemented, so don’t worry about this. Pin 1 is marked with a white dot on the board. Control Board ConnectorsĢ013-2017 Nissan Leaf Control Board Ver. If you have any questions, feel free to leave a comment. Please refer to the table below with my notes. I have seen a lot of questions about how to wire up Paul’s control board for the Nissan Leaf inverter.
0 Comments
Leave a Reply. |